Introductions:
You got a new Harddisk but your old PC does not support SATA?
You
have many harddisk (say more than 5) and your mainboad just supports 4
maximum. You got a way, don't waste your Parallel port even though it is
likely to be a little bit slower.
This is a BI-DIRECTIONAL converter, converting IDE to SATA or SATA to IDE.
UNIQUE FEATURE(S):
- Make your SATA HDD a External device.
General FEATURE(S):
- IDE to SATA 1.0
- SATA 1.0 to IDE
- Conversion Type switch
- LED Power indicator
- Easy installation & No drivers needed
- Automatic SATA 1.5 Gbps speed negotiation
- ATA / ATAPI PIO mode 0 to 4
- ATA / ATAPI Ultra DMA transfer rates: 16.7, 25, 33, 48, 66, 100, 133, 150 MB/s.
- ATA / ATAPI LBA48 addressing mode associated with 2-byte sector count
- Supports SATA hot-plug
- Ultra low power consumption
- Works for both AC & DC couple between transmitter and receiver
- Provides specified OOB signal detection and transmission
- Supports Spread Spectrum Clocking to reduce EMI (Electro-Magnetic Interference)
- Supports Partial/Slumber power management
- Provides adjustable TX signal amplitude and pre-emphasis level
- Supports Slave drives
- Adapters included to power unit from 4-pin Molex M/F, SATA, 4-pin floppy connectors
Colors Available:
- See picture above
Package Includes:
- Parallel and Serial ATA Bi-Directional Converter x 1
- SATA cable x 1
- SATA power and 4-pin male / female Molex power connector adapter x 1
Packaging:
- Blister
